Dinstar UC2000 - Codec; Number

UC2000 User Manual
42
Copyright @ 2011-2015 Dinstar
Polarity Reverse
If polarity reverse is on, call tolls will be calculated based on the changes
in voltage. If polarity reverse is off, you need to set the time for offhook
delay and call tolls will be calculated starting from the set time.
DTMF Send Interval(ms)
The minimum interval between the sending of two DTMF tone
DTMF: Dual Tone Multi Frequency
DTMF Gain
Signal gain of DTMF
DTMF Duration (ms)
The minimum duration of a DTMF tone
Detect Caller ID
Whether to detect caller ID; default value is ‘On’
Ring Detection
Detect caller ID after ringing or detect caller ID before ringing
Dialplan
The rules for dialing
4.6.3 Codec
UC2000 supports four codec modes, including G729, G723, PCMU and PCMA. You can adjust the
priority of these four modes according to you needs.
: Edit codec profile.
: Delete the corresponding codec profile or a codec mode.
: Create a new codec profile.
4.6.4 Number
On the Profile Number interface, you can set a prefix for calling numbers or called numbers. When the
prefix of a calling number or a called number matches the set prefix, the call will be passed to choose a
route.