dji MATRICE 4 Series - Flight Tasks

• As the PinPoint has altitude, when the aircraft looks at the PinPoint, it will
look at the altitude of the PinPoint. To look at the subject right below the
PinPoint, lock or adjust the gimbal angle manually after tapping the POI
icon.
4. Move the roll stick left or right to make the aircraft start to y clockwise or
counterclockwise. The more the stick is pushed away from the center position, the
faster the aircraft will move.
5. Once the desired speed has been reached, press the C1 button on the remote
controller or tap in the camera view to set the current speed as the POI speed.
The aircraft will automatically circle at the POI speed.
6. While the aircraft is circling automatically, users can move the roll stick left or right
to decrease or increase the circling speed. Once the desired speed has been reached,
press the C1 button on the remote controller or tap
in the camera view to set the
updated speed as the POI speed. The aircraft will automatically circle at the new POI
speed.
7. Tap the shutter/record button to take photos or start recording.
8. Press the ight pause button or the C1 button once on the remote controller or tap
in the camera view, the aircraft will brake and hover in place. Tap the POI icon in the
camera view to exit the POI mode.
• Only Single and Timed photos and video recordings are supported in POI mode.
• The maximum circling speed changes based on the current circling radius. The
larger the circling radius, the higher the maximum circling speed.
• While the aircraft is circling, if the user has changed the aircraft orientation with
the yaw stick so that the aircraft does not look directly at the selected PinPoint,
in this condition, if the user moves the pitch stick up and down, the aircraft will
not y forward or backward following current orientation. Instead, the aircraft
will y toward or away from the selected PinPoint.
7.3 Flight Tasks
Tap Flight Route on the homepage of DJI Pilot 2 to enter the ight route library, or tap the
ight route icon in the camera view or in the map view to enter the ight route library.
Users can view ight tasks or create a ight task.
DJI Matrice 4 Series User Manual
© 2025 DJI All Rights Reserved. 71