Adjust Flight Route Parameters
After the ight route is generated, tap on the Route Viewer to adjust the route
parameters. Refer to the Collecting Aerial Photogrammetry Data section for more
information about route parameters.
Tap Adjust Mapping Area to readjust the mapping area, if necessary.
Geometric Route
Geometric Route is used to collect photogrammetry data for multiple spatial surfaces,
which is mainly used for modeling and inspection of building facades.
Set the Bottom Base Shape
1. Select the shape type of the geometry base on the left side of the map view.
2. Tap on the map to draw the base shape of the geometry.
3. Tap
to conrm the bottom base of the mapping area.
• It is recommended to y the aircraft to the target building and mark its
boundary points. Then, enter the map view to draw the boundary points of
DJI Matrice 4 Series User Manual
© 2025 DJI All Rights Reserved. 81
To Next Page
Loading...
