dji MATRICE 4 Series - Collecting Aerial Photogrammetry Data

Collecting Aerial Photogrammetry Data
The following takes the Ortho Collection in the Area Route as an example for specic
operation instructions.
• Before collecting aerial photogrammetry data, enter the aircraft settings to
enable RTK, and ensure that RTK is connected and in FIX state.
1. On the homepage of DJI Pilot 2, tap Flight Route > Create a Route > to create an
Area Route. Tap on the map view, and drag the boundary point to adjust the range
of the mapping area. Tap in the middle of the boundary point to add a boundary
point, and adjust the longitude and latitude of the point in the parameter settings on
the right. Tap
to delete the current selected boundary point, and tap to delete all
boundary points.
2. Select the aircraft model, the camera model, and the lens, then set the following ight
route parameters in sequence:
a. Set the task name and select Ortho Collection.
b. Set the altitude mode (ASL/ALT), ight route altitude, ight route speed, course
angle, actions upon completion, etc., and enable elevation optimization.
c. In Advanced Settings, set the side overlap ratio, frontal overlap ratio, margin,
photo mode, and customize camera angle.
3. Tap
to save the task and tap to upload and execute the ight task.
4. Power o the aircraft after the task is completed. Remove the microSD card from the
aircraft, and connect it to the computer to check the taken photos and the generated
les.
DJI Matrice 4 Series User Manual
84 © 2025 DJI All Rights Reserved.