dji MATRICE 4 Series - Using Enhanced Transmission; Security Strategy; Remote Controller Usage Notes

Using Enhanced Transmission
After the aircraft and the remote controller are connected by a 4G network, Enhanced
Transmission can be enabled in the app.
• Go to the camera view, then tap the video transmission signal icon to enable or
disable Enhanced Transmission in the pop-up box.
• Go to the camera view, tap
> HD, and enable or disable Enhanced Transmission.
• Pay close attention to the video transmission signal strength after enabling
Enhanced Transmission. Fly with caution. Tap the video transmission signal icon
to view the current OcuSync video transmission and 4G video transmission
signal strength in the pop-up box.
Security Strategy
Based on safe ight considerations, Enhanced Transmission can only be enabled when
the OcuSync video transmission is in eect. If the OcuSync link is disconnected during
ight, it is not possible to disable Enhanced Transmission.
In a 4G-only transmission scenario, restarting the remote controller or DJI Pilot 2 will
result in failsafe RTH. The 4G video transmission cannot be restored before the OcuSync
link is reconnected.
In the 4G-only transmission scenario, a takeo countdown will start after the aircraft
lands. If the aircraft does not take o before the countdown ends, it will not be allowed to
take o until the OcuSync link is restored.
Remote Controller Usage Notes
If using the 4G network via the DJI Cellular Dongle 2, make sure to install the DJI Cellular
Dongle 2 correctly, and turn o the Wi-Fi of the remote controller while using Enhanced
Transmission to reduce interference.
DJI Matrice 4 Series User Manual
© 2025 DJI All Rights Reserved. 97