DMP Electronics XR500 SERIES Programming Guide

Digital Monitoring Products XR500 Series Canadian Programming Guide
14
MESSAGING SETUP
Messaging Setup
5.1
MESSAGING SETUP
Messaging Setup
This section allows you to enter the information needed to receive messages
directly from the panel via email and In Touch™ SMS Text using Network or Cellular
communication. All of the name and password options below allow up to 32
lowercasecharacterstobeentered.TheDestinationaddressesallowupto48
characters to be entered. System Name is displayed with initial caps.
The transmitted messages are:
      •ZoneAlarmsbyZoneName
      •ZoneTroublesbyZoneName
      •ZoneBypassbyUser
      •Arming(Closings)byUser
      •Disarming(Openings)byUser
      •LatetoClose
      •ACPowerTroubleandRestoral
      •SystemLowBattery
      •Ambush
      •Abort,CancelandAlarmVeriedbyUser
      •Check-inbyuser
5.2 Enable Messaging
Select YES to allow the panel to send messages to three programmed destinations.
Default is NO.
5.3
SYSTEM NAME
System Name
Enter a unique name for the panel. The panel name is used as the sender of the
message.Thetextenteredisdisplayedwithinitialcaps.Ifthiseldisleftblank,the
panel account number is sent.
5.4
DESTINATION 1
Destination 1
-
Entertherstemailaddressorcellphonenumberwheremessageswillbesent.The
messagecanbesenttoanydevice(computer,cellphone,PDA)aslongasavalid
email address or cell phone number is entered. When entering email addresses,
pressthe7digitkeyfollowedbythefourthSelectKeytoaddthe@symbolandthe
9 digit key followed by the fourth Select Key to add the _ symbol. See the Entering
Non-AlphaCharacterssectionforadditionalsymbols.
Note:MailserversthatrequireTransportLayerSecurity(TLS)encryptionarenot
supported by the XR500 Series.
5.5 Destination 1 User Number
IfDestination1isa10-digitcellularnumber,enterauser’susernumberfromthis
account. This option is used when sending commands such as arming or disarming
back to the panel using In Touch™ SMS Text from the same cell phone or PDA. The
user number must have the authority to perform the commands as if it occurred at the
keypad. In Touch™ SMS Text command operation is available in XR500 Series panels
usingversion205orhigher.Entering0(zero)disablesthisoption.Defaultis0.
5.6
DESTINATION 2
Destination 2
-
Enter the second destination email address or cell phone number.
5.7 Destination 2 User Number
If Destination 2 is a cellular number, enter the user’s User Number for
arming/disarmingauthorization.
5.8
DESTINATION 3
Destination 3
-
Enter the third destination email address or cell phone number.
ENABLE MESSAGING
NO YES
-
DESTINATION 1
USER NUMBER: 0
DESTINATION 2
USER NUMBER: 0

DMP Electronics XR500 SERIES Specifications

General

Brand	DMP Electronics
Model	XR500 SERIES
Category	Control Panel
Language	English