To Next Page

To Previous Page

Digital Monitoring Products XR500 Series Canadian Programming Guide

SYSTEM REPORTS

8.6

CODE CHG NO YES

Code Change Reports

YES allows the panel to send all code additions, changes, and deletions to the

receiver. The code change report includes the user name and number added or

deleted and the user name and number of the individual making the change. Code

changesmadethroughRemoteLink™arenotsenttotheprinterorDisplayEvents.

ReportsareonlysentifO/CUserinCommunicationsissetYESforReceiver1or

Receiver 2. The default setting is YES.

8.7

ACCESS KEYPADS:

Access Keypads

Selectthekeypadaddresses(1through16)thatsenddooraccessreportstothe

receiver. Enter the keypad number using the digit keys. An asterisk next to the

number indicates that the keypad is selected. Press COMMAND to display the next

set of keypads.

A report is sent with each door access made from the selected keypads. Keypads at

addresses not selected still operate the door relay but do not send access reports.

The report includes the user number, user name, keypad address, and device name.

8.8

AMBUSH NO YES

Ambush

YES allows an ambush report to be sent anytime user code number 1 is entered at

a keypad. NO disables the ambush report and allows user number 1 to operate the

same as all other codes.

8.9

PANIC TST NO YES

Panic Test Communication (XR500N/XR500E only)

YESallowsthepaniczonetestvericationandfailureresultstobesenttothe

central station receiver. NO disables the panic test report. The default setting is

NO.Thesystemteststart,stop,paniczoneverication,andpaniczonefailure

messages sent to the central station and the trips count operation are the same as

used under the Walk test. See Using the Walk Test section in the Appendix.

DMP Electronics XR500 SERIES Programming Guide

Other manuals for DMP Electronics XR500 SERIES