Digital Monitoring Products, Inc. XT Series Programming Guide
6
INITIALIZATION
Initialization
2.1 Initialization
This function allows you to set the panel’s programmed memory back to the factory
defaults. Select YES to clear the rst section of memory. The panel asks if you are
sure you want to clear that section’s memory. This is a safeguard against accidently
erasing part of the panel programming. No memory is cleared from the panel until
you answer YES to the SURE? YES NO option.
2.2 Clear All Codes
NO leaves existing codes intact.
YES clears the user code memory and assigns the user code number 99 to user 30 on
the XT30, and 99 on the XT50.
2.3 Clear All Schedules
NO leaves existing schedules intact.
YES clears all schedules from the XT30 or XT50 programming.
2.4 Clear Events
NO leaves existing event memory intact.
YES clears all event memory currently held in the panel’s Display Events buffer.
2.5 Clear Zone Programming
NO leaves existing zone information intact.
YES sets all zones in the system to * UNUSED *
2.6 Clear Communication
NO leaves existing communication, network, and e-mail programming intact.
YES clears communication, network and e-mail programming to factory defaults.
2.7 Clear Wi-Fi
NO leaves existing Wi-Fi programming intact.
YES clears Wi-Fi programming to factory defaults.
2.8 Set to Factory Defaults
NO leaves the remainder of the existing panel programming intact.
YES sets the panel’s programming back to factory default selections and clears all
Z-Wave, Favorites, Device Setup, System Options, and Remote Options programming
from the panel. Selecting YES does not clear the panel’s event memory, zone, user
code information, or schedules.
INITIALIZATION
CODES? NO YES
SURE? YES NO
SCHEDS? NO YES
SURE? YES NO
EVENTS? NO YES
SURE? YES NO
ZONES? NO YES
SURE? YES NO
COMM? NO YES
SURE? YES NO
WIFI? NO YES
SURE? YES NO
DEFAULTS? NO YES
SURE? YES NO
To Next Page
Loading...
Need help?
General
