XT Series Programming Guide Digital Monitoring Products, Inc.
37
STOP
Stop
15.1 Stop
At the STOP option, pressing any select key or area allows you to exit the
Programmer function of the panel. When selected, the panel performs an internal
reset and exits the programmer.
The STOP routine causes the following conditions to occur:
• All 1100 Series DMP Wireless transmitters are reset to NORMAL
• The panel Status List is cleared
During the reset, all keypad displays are momentarily blank for two seconds. After
the reset, the programming function terminates and the keypads return to the
status list display.
The STOP option does not disarm the system. Any new areas or zones that were
added during programming are not armed until the system is disarmed and armed
again.
Set Lockout Code
16.1 Set Lockout Code
Pressing COMMAND at the Stop option displays SET LOCKOUT CODE. This feature
allows you to program a special code that will then be required to gain access to
the panel’s internal Programmer through the keypad.
Changing the Lockout Code
You can change this code at any time to any combination of numbers from 1 to 5
digits long (1 to 65535). Do not use leading zeros for the lockout code.
1. Press any select key or area. The display changes to ENTER CODE: - .
2. Enter a 1- to 5-digit code (do not enter a number higher than 65535). Press
COMMAND.
3. Enter the new Lockout Code again. Press COMMAND. The keypad display changes
to CODE CHANGED.
Once you have changed the code, it is important that you write it down and store
it in a safe place. Lost lockout codes require the panel to be sent back into DMP for
repair. You may cancel a Lockout Code by entering 00000 at the Set Lockout Code
command option.
Lockout Code restriction:
Do not set a Lockout Code higher than 65535.
STOP
SET LOCKOUT CODE
SET LOCKOUT CODE
To Next Page
Loading...
Need help?
General
