XT Series Programming Guide Digital Monitoring Products, Inc.
13
MESSAGING SETUP
Messaging Setup
5.1 Messaging Setup
This section allows you to enter the information needed to send and receive
messages directly to and from the panel via Email and MyAccess™ text messaging
using network or cellular communication. All of the name and password options
below allow up to 32 lowercase characters to be entered. The Destination addresses
allow up to 48 characters to be entered. System Name is displayed with initial caps.
The transmitted messages are:
• Zone Alarms by Zone Name
• Zone Troubles by Zone Name
• Zone Bypass by User
• Arming (Closings) by User
• Disarming (Openings) by User
• Late to Close
• Late to Open
• Early to Close
• AC Power Trouble and Restoral
• System Low Battery
• Ambush
• Abort, Cancel and Alarm Veried by User
• Check-in by user
5.2 Enable Messaging
Select YES to allow the panel to send messages to three programmed destinations.
Default is NO.
5.3 System Name
Enter a unique name for the panel. The panel name will be used as the sender of
the message. The text entered will be displayed with initial caps. If this eld is left
blank, the panel account number will be sent.
5.4 Destination 1
Enter the rst Email address or cell phone number where messages will be sent. The
message can be sent to any device (computer, cell phone, etc) as long as a valid
Email address or cell phone number is entered. When entering Email addresses,
press the 7 digit key followed by the fourth select key or area to add the @ symbol
and the 9 digit key followed by the fourth select key or area to add the _ symbol.
See the Entering Non-Alpha Characters section for additional symbols.
Note: Mail servers that require Transport Layer Security (TLS) encryption are not
supported by the XT30/XT50.
5.5 Destination 1 User Number
If Destination 1 is a 10 digit cellular number, enter a user’s user number from this
account. This option is used when sending commands such as arming or disarming
back to the panel using MyAccess™ text messaging from the same cell phone. The
user number must have the authority to perform the commands as if it occurred at
the keypad. MyAccess™ text command operation is available in XT30/XT50 Series
panels using version 102 or higher. Entering 0 (zero) disables this option.
Default is 0.
5.6 Destination 2
Enter the second destination Email address or cell phone number.
5.7 Destination 2 User Number
If Destination 2 is a cellular number, enter the user’s User Number for
arming/disarming authorization.
5.8 Destination 3
Enter the third destination Email address or cell phone number.
5.9 Destination 3 User Number
If Destination 3 is a cellular number, enter the user’s User Number for
arming/disarming authorization.
MESSAGING SETUP
ENABLE MESSAGING
NO YES
SYSTEM NAME
-
DESTINATION 1
-
DESTINATION 1
USER NUMBER:
0
DESTINATION 2
-
DESTINATION 2
USER NUMBER:
0
DESTINATION 3
-
DESTINATION 3
USER NUMBER:
0
To Next Page
Loading...
Need help?
General
