8 XTLtouch Series Programming Guide | Digital Monitoring Products
CHECKIN REPORTS
Checkin reports are a method of supervising the panel for communication with the
receiver. Press a select area and enter the number of minutes between Checkin reports.
The range is 0 or 3-240 minutes. The default is 0. Entering 0 (zero) disables Checkin.
Note: If Cell Checkin is used, additional cell charges may apply.
FAIL TIME
Fail Time allows the SCS-1R or SCS-VR receiver to ignore a defined number of Checkins
before logging that the panel is missing. Fail Time must be equal to or greater than the
Checkin minutes. The range is 3 to 240 minutes. Entering 0 (zero) disables Fail Time.
SEND COMMUNICATION TROUBLE
If this option is enabled and the panel detects a communication failure, the panel
sends an S72 (Comm Trouble) message through a backup communication method with
notification of the failure. If both primary and secondary methods of communication
fail, then two S72 messages will be sent via the third communication method, if
programmed. When communication is restored, the panel sends an S73 (Comm
Restored) message through the primary communication. The default is NO.
Note: If the primary or secondary communication type is CELL, S72 and S73 messages
include the cell signal strength as a -dBm value.
FIRST CELL APN (Access Point Name)
This option allows an access point for cellular communication and is used to connect
to a DNS (domain name system) network. Press a select area to display the default,
SECURECOM400 or press a select area to change the name. The APN can contain up to
32 characters.
RECEIVER 1 PROGRAMMING
Press CMD to program the first receiver the panel attempts to send reports to.
ALARM REPORTS
Select YES to allow Abort, Alarm, Alarm Restoral, Alarm Bell Silenced, Ambush, Exit
Error, and System Recently Armed reports to be sent to this receiver. The default is YES.
SUPERVISORY/TROUBLE REPORTS
Select YES to allow Supervisory, Trouble, Trouble Restoral, Force Armed, Late to Close,
and Fault reports to be sent to this receiver. The default is YES.
OPENING/CLOSING USER REPORTS
Select YES to allow Opening/Closing, Code Changes, and Bypass reports of users to be
sent to this receiver. The default is NO.
TEST REPORT
Select YES to allow the Recall Test report to be sent to this receiver. The default is YES..
FIRST IP ADDRESS
Press a select area to enter the primary IP address where the panel sends network or
cellular information to. The message is sent using first Cell APN and the first IP Address.
If an acknowledgment isn’t received, the first Cell APN and the second IP address
are used and followed, if needed, by the second Cell APN and the first and second IP
addresses. Enter all 12 digits and leave out the periods. The default is 0.0.0.0.
CHECKIN 0
FAIL TIME
COM TRBL: NO YES
FIRST CELL APN:
RECEIVER 1 PROG
ALARM NO YES
SPV/TRBL NO YES
O/C USER NO YES
TEST RPT NO YES
FIRST IP ADDRESS
0. 0. 0. 0
To Next Page
Loading...
Need help?
General
