DMP Electronics XTLtouch - User Code Structure and Addition; User Code Elements Explained; Adding a New User Code

19 XTLtouch Series Programming Guide | Digital Monitoring Products
ARM ACTIVITY DAYS
This option allows you to select the number of days a system goes without any arming
and disarming activity. When the timer counts down to zero because of no arming or
disarming activity, the panel sends a “No Arming/Disarming” message to the receiver
at 10:00 AM. Each time an area is armed or disarmed, the timer is restarted. When the
countdown timer expires because of no arming or disarming activity, and a message
is sent, the timer does not restart until a panel reset occurs or an area is armed or
disarmed. The range is 00 to 99. The default is 0.
Note: The SUPV/TRBL receiver option must be enabled in Communication programming
for the message to be sent.
TIME ZONE CHANGES
This option allows the panel to request automatic time changes from the DMP SCS-1R
Receiver. For the receiver to send time changes, it must be programmed to send
time changes and must be receiving time change updates from the host automation
computer at least every 24 hours. The default is YES.
Enter the GMT number that indicates the Greenwich Mean Time (GMT) where the panel
is located. The default is 6. See the table below for GMT values.
GMT CITY/TIME ZONE GMT CITY/TIME ZONE
0 London, Monrovia, Lisbon, Dublin, Casablanca, Edinburgh 13 New Caledonia
1 Cape Verde Island, Azores 14 Guam, Sydney
2 Mid-Atlantic, Fernando de Noronha 15 Tokyo, Seoul
3 Buenos Aires, Georgetown, Brasilia, Rio de Janeiro 16 Hong Kong, Singapore
4 Atlantic Time (Canada), Caracas, La Paz, Santiago 17 Bangkok, Hanoi
5 Eastern Time (US, Canada) Bogota, Lima, Arequipa 18 Dhaka, Almaty
6 Central Time (US, Canada), Mexico City, Saskatchewan 19 Islamabad, Karachi
7 Mountain Time (US, Canada), Edmonton 20 Abu Dhabi, Kazan
8 Pacific Time (US, Canada), Tijuana 21 Moscow, Bagdad
9 Alaska 22 Eastern Europe
10 Hawaii 23 Rome, Paris, Berlin
11 Midway Island, Samoa
12 Fiji, Marshall Island, Wellington, Auckland, Kwajalein, Kamchatka
TIME DISPLAY
Select YES to allow the keypad to display the time and day in the Status List. The default
is YES.
HOUSE CODE
A Wireless House Code is pre-programmed at the factory. To change the house
code, press any select area and enter a number between 1 and 50. The XTLtouch
automatically programs the house code into the wireless transmitters when the unique
transmitter serial number is programmed into the panel. The house code identifies the
panel, receiver, and transmitters to each other. When operating, the receiver listens for
transmissions that have the programmed house code and transmitter serial number.
DETECT WIRELESS JAMMING
Select YES to enable jamming messages to display in the Status List. When enabled and
the receiver detects wireless jamming, a trouble or alarm message is sent to the receiver
and displays in the Status List. The default is NO.
ARM ACTY DAYS: 0
HRS FROM GMT: 6
TIME DSP YES
HOUSE CODE: 6
DET JAMNG NO YES
TIME CHG NO YES