4 XTLtouch Series Programming Guide | Digital Monitoring Products
BEGIN HERE
Access the Programmer menu in the XTLtouch. Once you have accessed the Programmer menu, press CMD to advance
through the menu. Press a select area to select a menu option and to access the functions of that option.
Access the Programmer menu
1. Remove the backplate from the XTLtouch.
2. Press the RESET button for two seconds.
3. On the keypad, press KEYPAD in the carousel menu.
4. Enter 6653 (PROG) and then CMD to access the Programmer menu.
Programmer Lockout Code
Although the XTLtouch allows access to the Programmer menu without a lockout code, you have the option to program
a lockout code to restrict Programmer access to authorized individuals only. Follow the directions below to program a
lockout code or wait until you get to the programming option when programming the XTLtouch.
Program a lockout code
Once you are in the Programmer menu, press CMD until SET LOCKOUT CODE displays and press a select key.
At ENTER CODE, enter a 1 to 5 digit lockout code and press CMD.
At ENTER AGAIN, enter the same lockout code and press CMD. The display shows CODE CHANGED. The new code
number must now be entered before the Programmer menu can be accessed.
Note: The lockout code should be written down and kept in a secure place with access limited to authorized persons
only. If you lose or forget the lockout code, the panel must be sent back to the factory to be reset. There is no field
option for gaining access to the panel without a valid lockout code if one has been programmed.
Reset Timeout
The XTLtouch has a feature that requires you to enter the Programmer menu within 30 minutes of resetting the panel.
After 30 minutes, if you attempt to program by entering 6653 (PROG), the keypad displays RESET PANEL. You must
reset the panel and enter the program code within the next 30 minutes.
If you are already in the Programmer menu and do not press any keys on the XTLtouch you’re programming for
30 minutes, programming is terminated. All data entered up to that point is saved in the XTLtouch.
To exit the Programmer menu, you must use the Stop function to save all information entered in the XTLtouch to that
point. Once you exit the Programmer menu, the XTLtouch returns to the home screen.
To Next Page
Loading...
Need help?
General
