DMP Electronics XTLtouch Programming Guide

13 XTLtouch Series Programming Guide | Digital Monitoring Products
DEVICE SETUP
Device Setup allows you to program wireless keypads in the system. You can install and address up to seven wireless
keypads. Addresses 2-8 are available for wireless keypads.
DEVICE SETUP
Press a select area.
DEVICE NUMBER
Enter the device number of the wireless keypad you’re programming. The valid range is
2-8. Keep in mind that Address 1 is reserved for the XTLtouch programming keypad that
you’re using right now. Repeat the steps in this section for each additional keypad.
DEVICE NAME
Press a select area to name the device you’re programming. To remove a keypad from
the system, press a select area to clear the name and then press the back arrow key.
SERIAL NUMBER
Enter the eight-digit serial number found on the wireless keypad.
SUPERVISION TIME
Press a select area to change the supervision time required for the device or press
CMD to accept the default time of 240 minutes. The device must check in at least once
during this time or a missing condition is indicated for that device. Zero (0) indicates an
unsupervised wireless keypad. When the XTLtouch is reset, powered down, powered up,
or programming is complete, the supervision timer restarts for all connected wireless
keypads.
Press the back arrow until DEVICE SETUP displays and press CMD to advance to the
next programming section.
DEVICE SETUP
DEVICE NO: -
* UNUSED *
SERIAL #:
SUPRVSN TIME: 240

DMP Electronics XTLtouch Specifications

General

Brand	DMP Electronics
Model	XTLtouch
Category	Security System
Language	English