48 XTLtouch Series Programming Guide | Digital Monitoring Products
LISTED COMPLIANCE SPECIFICATIONS
The programming and installation specifications contained in this section must be completed when installing the
XTLtouch in accordance with any of the ANSI/UL or SIA burglary standards. Additional specifications may be required
by a particular standard.
Use Marking
Commercial Central Station, Household Burglar Control Unit, and Residential Fire.
Locations and Wiring
Locations and wiring methods shall be in accordance with the National Electrical Code, ANSI/NFPA 70 and the Standard
for Installation and Classification of Burglar and Holdup Alarm Systems, UL 681.
NFPA 72
This equipment should be installed in accordance with Chapter 29 of the National Fire Alarm Code,
ANSI/NFPA 72, (National Fire Protection Association, Batterymarch Park, Quincy, MA 02269). Printed information
describing proper installation, operation, testing, maintenance, evacuation planning, and repair service is to be provided
with this equipment. Warning: Owner’s instruction notice, not to be removed by anyone except occupant.
Types Of Service
Suitable for Central Station Burglar. Suitable for Household Fire and Household Burglar. Test weekly. The XTLtouch has
not been evaluated by Intertek for Household Fire.
Police Station Phone Numbers
The XTLtouch must not be programmed to communicate with a police station.
Bypass Reports
The bypass reports must be programmed as YES for all listed burglary applications.
System Testing
The system must be tested once per week and checked by a qualified technician once every three (3) years.
FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of
your body.
This device must not be collocated or operating in conjunction with any other antenna or transmitter.