DMP Electronics XTLtouch Programming Guide

15 XTLtouch Series Programming Guide | Digital Monitoring Products
SYSTEM REPORTS
System Reports allows you to select which reports the XTLtouch sends to the receiver.
SYSTEM REPORTS
Press any select area.
OPENING/CLOSING REPORTS
Select YES to allow them to be sent to the receiver for each programmed area. The
default is NO.
ABORT REPORTS
Select YES to allow the XTLtouch to send an Alarm Abort Report to the receiver when
an area is disarmed during Transmit Delay before an alarm report is sent and the Bell
Cuto Time has not expired. The area and all alarmed zones must be disarmed. Enabling
this option also allows a Bell Silenced Report to be sent to the receiver if the alarm bell
is silenced with a valid user code during an alarm. The default is NO.
Note: Alarm Cancel or Verify Reports are sent if the alarm is canceled or verified after
being sent to the receiver if the Bell Cuto timer has not expired. The Abort Reports
option does not aect Cancel or Verify reports. The XTLtouch will not send Abort
reports for Fire or Supervisory-type zones.
ZONE RESTORAL REPORTS
Select YES to allow the XTLtouch to send zone restoral reports to the receiver when
zones restore from an alarmed or troubled condition. Select NO to allow the XTLtouch
to send zone restoral reports when zones that have restored from an alarm or trouble
are disarmed. Twenty-four hour zones send restorals immediately. The default is YES.
BYPASS REPORTS
Select YES to allow the XTLtouch to send all zone bypass, reset, and force arm reports
to the receiver. The bypass report includes the zone number, zone name, and the user
number of the user bypassing the zone. The default is YES.
CODE CHANGE REPORTS
Select YES to allow the XTLtouch to send all code additions, changes, and deletions to
the receiver. The code change report includes the user number added or deleted and
the user number of the user making the change. The default is NO.
SEND STORED MESSAGES
If a panel loses communication with the receiver, it will store any messages that are
not able to be sent while communication was down. Select YES to allow the XTLtouch
to send all stored messages to the receiver when communication is restored. The time
at which each message was generated is also sent. If the panel is programmed to
communicate to a second IP address (IP2), SEND STORED MESSAGES must be enabled
for the panel to send a special check-o message to IP2 once communication is restored
to the primary IP address (IP1). The default is NO.
AMBUSH
Select YES to allow an ambush report to be sent to the receiver when User Code 1 is
entered at a keypad. Selecting NO disables the ambush report and allows user code
number one to operate the same as all other codes. The default is NO.
SYSTEM REPORTS
O/C RPTS NO YES
ABORT NO YES
RESTORAL YES NO
BYPASS NO YES
CODE CHG NO YES
SEND STORED
MESSAGES? NO YES
AMBUSH NO YES

DMP Electronics XTLtouch Specifications

General

Brand	DMP Electronics
Model	XTLtouch
Category	Security System
Language	English