41 XTLtouch Series Programming Guide | Digital Monitoring Products
APPENDIX
This section provides additional zone and system information.
Status List
The Status List is the current status of the system or records of recent system events that display on alphanumeric
keypads. For example, in Home/Away systems you may see the display SYSTEM READY.
If an event were to occur on the system, such as an AC failure, the keypad would also display the AC POWER -TRBL
message. This is a system event that is placed into the Status List to alert the user to a problem with the system.
Some Status List items remain in the display until manually cleared and some are cleared automatically when the
condition returns to normal. Below is a list of status and event displays the keypad can show in the Status List:
Description Must be manually cleared?
Fire and Supervisory zone alarms Yes - by Sensor Reset
Fire and Supervisory zone troubles No - clears when zone restores
Burglary zone alarms No - clears at disarming.
All other zone alarms No - clears when zone restores
Zone monitor displays No - clears after approximately 8 minutes
Day zone alerts No - clears after approximately 8 minutes
System monitor troubles No - clears when condition restores
(AC and battery trouble)
Armed status display No
(System On)
Disarmed status displays No
(System Ready, System Not Ready)
Remote keypad messages No
(Sent to the keypad by your oce or central station)
The highest priority message is displayed on the keypad. When there are multiple items in the list, you can use CMD or
the Back Arrow to scroll forward or back through the items.
Transmission Delay
You can set Abort Reports to YES if Opening and Closing reports are not being sent.
If the area where the alarm occurred is disarmed during the Transmit Delay time, only an Abort Report (S45) message is
sent to the receiver. If the area where the alarm occurred is disarmed after the alarm message is sent to the receiver but
before the Bell Cuto time expires, even if the alarm was silenced, an Alarm Canceled (S49) message is sent. The Alarm
Canceled report cannot be disabled.
False Alarm Reduction
System Recently Armed report
The System Recently Armed report (S78) is sent when a burglary zone goes into alarm within two minutes of the system
being armed.
To Next Page
Loading...
Need help?
General
