DMP Electronics XTLtouch Programming Guide

9 XTLtouch Series Programming Guide | Digital Monitoring Products
FIRST IP PORT
Press a select area to enter the first IP port number that will be used with the first IP
Address. The IP port identifies the port used to communicate messages to and from the
panel. The default is 2001.
SECOND IP ADDRESS
Enter the second (secondary) IP address where the panel sends network or cellular
information. Enter all 12 digits and leave out the periods, they will auto-generate.
SECOND IP PORT
Enter the second IP port number to be used in conjunction with the second IP address.
The IP port identifies the port used to communicate messages to and from the panel.
The default IP Port setting is 2001.
RECEIVER 2 PROGRAMMING
Press CMD to program the second receiver the panel attempts to send reports to. If
you select YES for any of the Receiver 2 options, you must have at least one IP address
programmed in Receiver 2 programming. All Receiver 2 programming options are
defaulted to NO.
RECEIVER 2 BACKUP?
Select NO to allow Receiver 2 to send dual messages to the central station. Select YES
to allow Receiver 2 to start receiving messages only when Receiver 1 stops working.
Receiver 2 will return to its backup state when Receiver 1 returns to its normal sate. The
default is NO.
ALARM REPORTS
Select YES to enable Abort, Alarm, Alarm Restoral, Alarm Bell Silenced, Ambush, Exit
Error, and System Recently Armed reports to be sent to this receiver. Default is NO.
SUPERVISORY/TROUBLE REPORTS
Select YES to allow Supervisory, Trouble, Trouble Restoral, Force Armed, Late to Close,
and Fault reports to be sent to this receiver. Default is NO.
OPENING/CLOSING AND USER REPORTS
Select YES to allow Opening/Closing, Code Changes, and Bypass reports by user to be
sent to this receiver. Default is NO.
TEST REPORT
Select YES to allow the Recall Test report to be sent to this receiver. Default is NO.
FIRST IP ADDRESS
Press a select area to enter the primary IP address where the panel sends network or
cellular information to. The message is sent using first Cell APN and the first IP Address.
If an acknowledgment isn’t received, the first Cell APN and the second IP address
are used and followed, if needed, by the second Cell APN and the first and second IP
addresses. Enter all 12 digits and leave out the periods. The default is 0.0.0.0.
FIRST IP PORT
Press a select area to enter the first IP port number that will be used with the first IP
Address. The IP port identifies the port used to communicate messages to and from the
panel. The default is 2001.
FIRST PORT IP
2001
SECOND IP ADDRESS
0. 0. 0. 0
SECOND IP PORT
2001
RECEIVER 2 PROG
ALARM NO YES
SPV/TRBL NO YES
O/C USER NO YES
TEST RPT NO YES
FIRST IP ADDRESS
0.0.0.0
FIRST PORT IP
2001
BACKUP?
NO YES

DMP Electronics XTLtouch Specifications

General

Brand	DMP Electronics
Model	XTLtouch
Category	Security System
Language	English