2 XTLtouch Series Programming Guide | Digital Monitoring Products
On-Board 1100 Series Wireless
Wireless Antenna
The XTLtouch Wireless Antenna is integrated into the circuit board. The panel’s built-in wireless receiver operates with
DMP 1100 Series transmitters.
Wireless LED Operation
The wireless LEDs are located on the back of the unit under the backplate and function as follows:
▶ Green: The green LED flashes every time the receiver transmits. If the panel is reset, or the panel is powered o,
the green LED is o. Under normal operation, the green LED flashes constantly with no interruption or change.
▶ Yellow: The yellow LED flashes every time the panel receives a message from a programmed wireless
transmitter. When a message is sent by a transmitter, typically by pressing or releasing the TAMPER button,
the yellow LED should flash indicating that the panel received a message from the transmitter. If the LED never
flashes, the transmitter is not getting through to the panel. This could be because of a misprogrammed serial
number or the transmitter is too far away. Under normal operation, the yellow LED flashes at every trip of every
wireless transmitter and when the transmitters perform their periodic check-in. It is not unusual for this LED to
stay o for many minutes at a time when no transmitters are communicating.
Wireless Keypads
XTLtouch supports up to seven additional wireless keypads on addresses 2-8.
Wireless Zones
XTLtouch provides 99 wireless zones numbered 1 to 99. A default zone name, zone type, and area assignment are
provided for zones 1-48 and can be changed in Zone Information programming as needed. The defaults are provided as
a programming convenience to help reduce installation time.
Wireless Key Fobs and Outputs
The XTLtouch provides eight wireless key fob or output addresses numbered 51 to 54 and 61 to 64. A default name
is provided as a programming convenience to help reduce installation time. The default names are described in the
programming sections of this guide and can be changed in Output Information or Zone Information programming as
needed.
On-Board Z-Wave Connection
The XTLtouch features an on-board controller that allows short range radio control of Z-Wave devices that you or your
installation company may provide such as lighting control modules, thermostat controls, doors, and garage doors.
Z-Wave Setup allows you to program the system to control the Z-Wave devices from smartphones using the DMP Virtual
Keypad App or with the Virtual Keypad Browser. The available setup options are: Add, List, Remove, Favorites, Transfer,
and Optimize.
On-Board Wi-Fi Network
The XTLtouch connects directly to a Wi-Fi network for TCP communication using a Wireless-B/G connection. The
XTLtouch uses wireless 802.11b/g Wi-Fi technology.
Wi-Fi LEDs
The Green Wi-Fi LED is located to the right of the wireless LEDs on the back of the unit under the backplate.
Wi-Fi LED displays solid when the network is connected and is o when there is no network connectivity.
To Next Page
Loading...
Need help?
General
