DC-TEC-MAN-CL96_B
DODtec.com
REV 1/9/2024 815-788-5200
Page 10 solutions@dodtec.com
ChemLogic® CL96 Operating Manual
2.1.1 Status Lamp (OPTIONAL)
The optional status lamp consists of 4 colored lights – Red, Orange, Blue, and Green along with an audible
alarm. See Appendix A for ordering information.
2.1.2 Output Wiring Knockouts
Knockouts for output wiring are located on the right-side panel near the top.
2.1.3 Touch Screen Display
The CL96 uses a full color 19-inch touch panel LCD display. All menus and data entry are accomplished by
touching the appropriate area of the screen – see Chapter 5 “Basic Operation”.
2.1.4 Keyed Service Door Access
The door uses a key lock to restrict internal access. See section 2.3 for detailed information on the service
area.
2.1.5 A/C Power & Switch
A/C power is connected on the right-side panel with a standard cable. The on/off power switch is located
adjacent to the power cable connection.
2.1.6 Flow Adjustment
Flow adjustments for all installed points are located on the top of the device. Refer to section 5.2.4 regarding
flow adjustment.
2.1.7 ChemLogic Cassette Paper Tape
ChemLogic paper tapes are accessed by opening the maintenance door. Refer to section 6.3 regarding tape
installation/replacement.
2.1.8 Maintenance Door
The maintenance door allows easy access to the ChemLogic tape for installation and replacement.
IMPORTANT : The maintenance door should remain closed and latched except when changing
the ChemLogic cassette tape. Do not open the door while in Analysis Mode.
To Next Page
Loading...