DC-TEC-MAN-CL96_B
DODtec.com
REV 1/9/2024 815-788-5200
Page 26 solutions@dodtec.com
ChemLogic® CL96 Operating Manual
6.1.c Faults/Events
Touching the Faults/Events buttons on the main menu will bring up the screen show in figure 6.1.c. Note this
important difference between this screen and the fault/events screen on the ‘History’ sub-menu. The
faults/events on the main menu shown on figure 6.1.c retains a list of the most recent events (128-256).
Regardless of whether a USB drive is inserted this list will show the most recent events. Each new fault or
event is added to the top of this list and also written to the USB drive (if available).
Touch the ‘Fault/Alarm Reset’ button to reset clear all active faults & alarms.
Figure 6.1.c
NOTE : New events may not immediately appear on the list while the screen is active. Each
time the menu item is selected (from another menu) the current list is activated.
To Next Page
Loading...