DOD Technologies ChemLogic CL96 - Chapter 5 General Machine Operation; 5.1 Introduction; 5.2 General Screen Navigation

DC-TEC-MAN-CL96_B
DODtec.com
REV 1/9/2024 815-788-5200
Page 19 solutions@dodtec.com
ChemLogic® CL96 Operating Manual
Chapter 5 General Machine Operation
5.1 Introduction
The touch screen on the CL96 is used for all configuration and control of the unit. Analysis mode is active by
default approximately 2 minutes after power on unless an operator intervenes. The machine is designed to
continually monitor for gas 24/7. Various tasks can be completed while remaining in analysis including
viewing faults and events, viewing Concentration history & TWA logs, checking point configuration and flow
limits. Access to the help menu is also available while remaining in analysis.
Analysis is started either by:
1. Power on timeout without user intervention, approx. 2 minutes)
2. Touching the Start Analysis button for a specific analyzer on the Load Tape screen.
3. Touching the ‘Analysis’ button on the Main Menu which will start analysis for all installed analyzers at
the same time.
Analysis will continue until one of the following occur:
1. Power loss.
2. Touching the ‘Stop Analysis’ button for a specific analyzer on the Load Tape screen. (password may be
required)
3. Entering Setup by touching the Setup button on the main menu and entering an appropriate password
which will halt analysis on all analyzers.
4. A critical machine fault which may stop an individual analyzer or the entire CL96.
5.2 General Screen Navigation
Figure 5.2.1
Figure 5.2.1 shows a portion of the main menu that appears at the top when the machine is powered on. The
menu system on the CL96 allows simple access to all the functionality of the system with a simple
touchscreen interface. The selected item on the menu (“Analysis” on the figure 5.2.1) will appear in slightly
larger
BOLD text with a lighter shade of gray as the background.
A few things to know about all the menus on the CL96:
• The background color of the top menu area always indicates the status of the machine and will match
the color of the optional light attachment. Table 5.2 explains the colors: