DC-TEC-MAN-CL96_B
DODtec.com
REV 1/9/2024 815-788-5200
Page 85 solutions@dodtec.com
ChemLogic® CL96 Operating Manual
Appendix I – Unified Exhaust Option Installation
The Unified Exhaust Manifold (2-800-073) for the CL96 is an option that combines the 12 individual exhaust
tubes into a single manifold. The CL96 Exhaust Manifold tubing can handle up to 50’ (using a qty of 2, part# 2-
400-048).
The Unified Exhaust Manifold was designed to take the 12 exhaust tubes as an input, and output as one larger
unified exhaust tube. The exhaust manifold output port can be mounted such that it can face upward or
downward (dependent upon the customer installation requirements).
Qualified personnel are required to perform the installation.
Installation instructions
1. Required tools
1.1. Masking tape (used for paper template).
1.2. #2 phillips screwdriver.
1.3. 7/8″ Socket, 6-Point, deep well socket.
1.4. 1″ Socket, 6-Point, deep well socket.
1.5. Ratchet Driver to fit deep well sockets.
1.6. Center punch.
1.7. Drill.
1.8. 7/32” drill bit.
1.9. Drop cloth to capture metal shavings while drilling holes.
1.10. Small vacuum to remove any metal shavings.
2. Preparation
2.1. Disconnect power to the CL96. Ensure your facility utilizes Lockout processes.
2.2. Verify no power is supplied to the system prior to opening the system for installation.
2.3. Remove the CL96 rear panel screws (3) using a #2 Phillips screwdriver.
2.4. After the screws have been removed lift/slide the rear panel up for removal. Use caution as the panel
has a grounding wire connected in the lower corner. Ensure the wire connection is not damaged. The
ground wire is long enough to provide access to the exhaust ports.
2.5. Label each of the individual exhaust tube according to the exterior panel label. The labeling with help
identifying which exhaust tube to re-install after Exhaust Manifold has been mounted to the side of
the enclosure.
To Next Page
Loading...