DC-TEC-MAN-CL96_B
DODtec.com
REV 1/9/2024 815-788-5200
Page 75 solutions@dodtec.com
ChemLogic® CL96 Operating Manual
Appendix G – Optional Secondary Enclosures
WARNING :Disconnect power before servicing.
Many of the I/O options for the CL96 are packaged as secondary enclosures. These secondary enclosures are
typically located remotely, mounted on the side or close to the CL96 cabinet. This section describes mounting
(G.1), A/C Power (G.2), connecting to the CL96 (G.3), and external wiring (G.4) for the varying options available.
G.1 Mounting A Secondary Enclosure
Before mounting the secondary enclosure, be sure to read through sections G.2, G.3 and G.4 to understand and
design your wiring requirements for A/C power to the unit and wiring to the I/O modules. It may be necessary
to drill the opening for the wiring before mounting depending on the location selected for each cabinet.
Optional enclosure(s) must be firmly mounted before wiring.
G.1.1 Remote Secondary Enclosure Mounting
If the enclosure is to be mounted externally use the provided mounting brackets to secure the cabinet at the
desired location.
G.1.2 Direct mounting on the CL96
If specified at time of purchase, the CL96 cabinet can be pre-drilled to easily mount secondary enclosures to
the side of the cabinet. The CL96 cabinet will have four (4) bolts mounted on the side for each (max 2) cabinet
that mounts on the side panel. – See figure G.1.1.
Figure G.1.1
To Next Page
Loading...