DC-TEC-MAN-CL96_B
DODtec.com
REV 1/9/2024 815-788-5200
Page 58 solutions@dodtec.com
ChemLogic® CL96 Operating Manual
a. When the reference validation occurs, a general fault is triggered and all points on the affected optic
block are disabled (4 points)
3. REF FAULT DISABLE POINT
a. When the reference validation occurs, a general fault is triggered and the single affected point is
disabled (1 point)
6.3.f Setup -> Factory -> Restore
6.3.g Setup -> Factory -> Update
IMPORTANT : If only number 1 (REFERENCE FAULT CRITICAL) is enabled, it will remain
enabled until the CL96 is power cycled. After a power cycle the fault will need to be re-enabled.
Number 2 and 3 below will remain enabled during a power cycle.
To Next Page
Loading...