DC-TEC-MAN-CL96_B
DODtec.com
REV 1/9/2024 815-788-5200
Page 39 solutions@dodtec.com
ChemLogic® CL96 Operating Manual
6.2.c.2 Setup -> Outputs -> Point Alarms
When the Test Points button is touched the screen below is displayed. The buttons along the top allow
selections of each analyzer that is installed (if not installed the button are disabled). The same screen is used
to test the 24V output modules and/or the relay contacts if installed. For each installed point, the touch
buttons allow the operator to toggle the outputs active/in-active. Depending on the system setting for the
Energized/De-energized relays the output is set accordingly.
In figure 6.2.c.2 below, several of the point alarms have been selected for analyzer A1.
Figure 6.2.c.2
To Next Page
Loading...