DC-TEC-MAN-CL96_B
DODtec.com
REV 1/9/2024 815-788-5200
Page 36 solutions@dodtec.com
ChemLogic® CL96 Operating Manual
Figure 6.2.a.2
6.2.b Setup -Adjust Flow
When the Adjust Flow, button is touched the screen below appears. The buttons along the top allow selection
of each analyzer that is installed (if not installed the buttons are disabled). Touch the button for the analyzer
once to turn on the pump for that analyzer or touch the same button again to turn off the pump. When the
button is touched the flow levels for those 16 points are displayed below and may be adjusted with the
corresponding flow control valves on the top of the machine. Only 1 analyzer may be selected at a time.
IMPORTANT : When a point is disabled no gas analysis is performed.
To Next Page
Loading...