DC-TEC-MAN-CL96_B
DODtec.com
REV 1/9/2024 815-788-5200
Page 25 solutions@dodtec.com
ChemLogic® CL96 Operating Manual
6.1.b Load Tape
Touching the ‘Load Tape’ button on the main menu will bring up the screen shown below. Note that stacked
analyzers can only be operated together although each analyzer tray can be started and stopped
independently. From this screen the operator can also stop analysis for an individual analyzer to allow new
tape to be loaded into the system. During Analysis, the buttons for “Open Gate”, “reset Counter”, and “Verity
Optics” are all disabled. The background color of each analyzer will match the status of the analyzer since
each analyzer tray can be started / stopped independently.
When loading a new tape follow the procedure described in Chapter 7.
Figure 6.1.b
To Next Page
Loading...