DC-TEC-MAN-CL96_B
DODtec.com
REV 1/9/2024 815-788-5200
Page 86 solutions@dodtec.com
ChemLogic® CL96 Operating Manual
2.6. Next disconnect the interior exhaust fittings/plugs from the side panel bulkhead fittings. Press the
fittings collet to release all tubing from the side panel bulkhead fittings. Set plugs aside to re-install
at later time.
Images 1 2, and 3: Exterior and Interior Views from back of CL96 side panel. Tubing fittings/plugs and bulkhead
fittings.
2.7. After the exhaust fittings are disconnected from the bulkhead fittings from the interior of the CL96
the exterior exhaust tubing also needs to be disconnected.
2.8. Next remove the bulkhead fittings from the CL96 side panel. Utilize the 7/8″ Socket, 6-Point, deep
well socket for the exterior and the 1″ Socket, 6-Point, deep well socket for the interior to remove the
bulkhead fitting.
Image 4: CL96 side panel view with bulkhead fittings removed.
2.9. The system is now ready to use template to drill holes for mounting the Exhaust manifold.
To Next Page
Loading...