DC-TEC-MAN-CL96_B
DODtec.com
REV 1/9/2024 815-788-5200
Page 87 solutions@dodtec.com
ChemLogic® CL96 Operating Manual
3. Exhaust Manifold mounting holes (Skip this section 3 if the side panel has the holes pre-drilled).
3.1. Utilizing the pdf named CL96 Unified Exhaust Customer Cutout Template. Align the larger diameter
holes with the holes in the side panel where the bulkhead fittings were previously installed. Verify the
outline of the holes from the template are visibly aligned with the holes of the side panel. View from
the interior and exterior of the enclosure to ensure alignment.
Images 5 and 6: CL96 side panel view with template affixed to the side panel.
3.2. Place drop cloth or other method to prevent metal shavings from drilling are captured.
NOTE: Ensure metal fillings are completed removed from the enclosure interior to prevent shorts or
any other damage.
3.3. After drop cloth or other method to prevent metal shavings from drilling is in place, use a center
punch to mark the (4) smaller hole centers on the template.
Image 7: CL96 side panel view with template affixed to the side panel.
To Next Page
Loading...