Heat the crankshaft gear for at least 10 minutes to
120°C, then apply sealant (Loctite # 641) to the inside
wall of the heated crankshaft gear evenly before
inserting it to the end of crankshaft.
Semi-tighten a bolt at both sides of the crankshaft,
apply engine oil to journals and pins, then assemble the
crankshaft with the cylinder block by tightening the fixing
bolts.
Caution:
Coat engine oil to the pin and journal of crankshaft.
Install the oiled thrust washers with the oil groove
facing outward.
Install the bearing and thrust washers to the bearing
cap and apply oil to the bearing and thrust washers.
5ton Diesel Engine SPC000006
Page 65
To Next Page
Loading...
