Fasten power take-off in a vise.
Expand the two snap rings, align them centrically
and drive the drive dog provisionally about 5 ... 10
mm ahead (direction of Arrow).
NOTE:
For this step, an assistant is absolutely necessary!
(S) Circlip pliers 5870 900 026
Squeeze out snap ring (Figure 29), tap the drive dog
loose and drive it out of the spur gear, resp. housing
bore (Figure 30).
NOTE:
Pay attention to the released components!
Transmission and Torque Converter SPC000007
Page 93
To Next Page
Loading...
