NOTE:
For the following steps pay attention to the Draft (Figure 93) !
Squeeze in circlip 1.
Tilt gear case 180.
( S ) Clamping pliers 5870 900 021
Lay shim 2 (e.g. s = 0,7 mm/empirical value) and
roller bearing 3 upon circlip 1.
NOTE :
The end play of the output shaft bearing is
determined by means of shim 2.
However, a later check of the end play (Figure 104
to Example "A") is absolutely essential !
SPC000007 Transmission and Torque Converter
Page 106
To Next Page
Loading...
