3.2.2 Speedometer
The Illustration on the left shows the components.
1 = Speedometer-drive gear
2 = Speedometer-drive shaft
3 = Straight pin
4 = Speedometer connecting piece
5 = Shaft seal
Press drive gear flat against the end face/
speedometer-drive shaft.
Introduce speedometer-drive shaft and fix it by
means of straight pin.
Guide installer ( S ) over the speedometer-drive
shaft and install shaft seal (Arrow) with the sealing
lip facing the oil chamber.
( S ) Driver 5870 048 072
SPC000007 Transmission and Torque Converter
Page 114
To Next Page
Loading...
