Doosan DISD SD 310 - Page 399

4.2 REASSEMBLY
4.2.1 Pre-assemble and attach Retarder
Heat bearing bore and insert 4-point bearing firmly
against shoulder.
Adjust the 4-point bearing free of play by means of
disk (optional) and circlip.
NOTE :
Pay attention that the two bearing inner races are
present !
If necessary, insert upper bearing inner race and
intall shaft seal.
NOTE :
The exact installtion position is obtained by
application of the prescribed driver !
( S ) Driver 5870 048 068
Install stator ring.
Transmission and Torque Converter SPC000007
Page 171
Figure 20
Figure 21
Figure 22
Figure 23