7.2 REASSEMBLY
Close the two bores by means of set screws see
Arrows !
NOTE:
Insert set screws with Loctite (Type-No.270).
Mount circlip and press ball bearing against
shoulder until contact is obtained.
Insert needle bush in the drive shaft bore until
contact is obtained.
NOTE ;
Install needle bush with the reinforced shell facing
the pressing tool.
( S ) Driver 5870 058 013
( S ) Handle 5870 260 002
Fix ball bearing by means of circlip.
SPC000007 Transmission and Torque Converter
Page 216
To Next Page
Loading...
