Install radial lip-type sealing rings according to the
Figure on the left.
1 = Piston
2 = Radial lip-type sealing ring (internal)
3 = Radial lip-type sealing ring (external)
4 = Pressure side
NOTE :
Sealing lip facing the pressure side !
Oil radial lip-type sealing rings and insert piston
carefully until contact is obtained.
( S ) Clamping pliers 5870 900 007
Install compression spring and disk.
NOTE :
Install disk with the reduced plane surface facing the
compression spring !
Preload compression spring by means of assembly
jig ( S ) and fix it by means of circlip (Arrow).
( S ) Assembly jig 5870 345 028
SPC000007 Transmission and Torque Converter
Page 218
To Next Page
Loading...
