5. Install input flange
Put gasket on the end face of bracket, install sealing
cover assembly (coat lubrication grease on oil seal
according to common requirements of drive axle),
and connect with bracket with bolts and gaskets.
Note: Screw fastening torque 145
5Nm
6. Install input flange.
7. Coat sealant on one end face of gasket, the
surface with sealant is downward, install gasket.
Note: Letai 598 sealant
8. Install round screws and fasten.
Note: Screw fastening torque
320 ~ 400 Nm
Note: Letai 598 sealant
Front Axle SPC000009
Page 41
To Next Page
Loading...
