14. Assemble main drive assembly
Coat Letai 598 silicon rubber surface sealant at the
joint surface between shell and bracket, coatφ3φ6
glue soluting ring with sealing surrounding inside of
thread hole at the large end of shell. The coated
sealant cannot be in the air for more than ten minutes.
Note: Letai 598 silicon rubber surface sealant
15. Assemble main drive
Hand up main drive assembly with overhead crane,
put main drive at main drive shell of the axle,
assemble locating pin.
16. Assemble bolts
Coat proper Letai 262 threat fastening sealant on bolts,
the coating position is 15mm length at thread end.
Fasten main drive assembly and shell assembly with
bolts and gaskets.
Note: Fastening torque
180 ~ 210Nm
Letai 262 threat fastening sealant
Fasten all screws according to symmetrical and
crossing principle.
17. Add oil
Add 17L 85W/90 GL-5 gear oil (GB13895-1992) in
axle bag of shell and fasten plug screws.
Note: use 85W/90 GL-5 gear oil
Anaerobic type pipe threat sealant
Fastening torque
175 ~ 235 Nm
SPC000010 Rear Axle
Page 30
To Next Page
Loading...
