Doosan DISD SD 310 - Page 571

9. ① Assemble the bolts and tighten the bolts with
in a crisscross pattern to a torque value of 140 Nm.
10. ① insert a through shaft to the 1
st
working
section.
② locate 2nd working section to the rear of 1st
working section
11. ① Assemble the bolts and tighten the bolts with
in a crisscross pattern to a torque value of 45 Nm.
Steer Pump SPC000013
Page 13
Figure 21
Figure 22
Figure 23