1.7 Validity and Responsibility
This manual does not provide information about the design, installation and operation methods of
robot applications integrated with other system. In addition, this manual does not provide information
that may influence the safety of the integrated system.
The system administrator must install the robot in a way that observes various safety requirements
according to the related national standards and regulations. In addition, the staff in charge of
integrating and managing the robot in a system must ensure that all related national safety legislation
and regulations are observed. The entity or user of the final system in which the robot is integrated has
the following responsibilities, and such responsibilities are not limited to the items listed below.
• Risk assessment of the system with the robot integrated
• Installation and removal of safety devices according to the outcome of the risk assessment
performed
• Confirmation of whether the system is properly designed, set up and installed
• Establishment of system operation and instructions
• Management of suitable safety settings in the software
• Prevention of users modifying safety devices
• Validity check of design and installation of integrated system
• Indication of contact information or important notifications related to use and safety
• Provision of technical documents including various manuals
• Provision of information on standards and legislation applied: http://www.doosanrobotics.com/
Compliance with the safety requirements in this manual does not mean all risks can be prevented.
To Next Page
Loading...
Need help?
General
