Issued June 2020
Operation
Copyright 2020, Heil Environmental
Printed in U.S.A.
96
UNLOADING AN EJECT UNIT (CONTINUED)
Prop the Tailgate
Before you clean and inspect the tailgate seal, prop the
tailgate with the two factory body props. See Propping the
Tailgate .
Clean/Inspect Tailgate Seal
BEFORE you lower the tailgate, MAKE SURE the area
where the tailgate seal mates with the body is CLEAN AND
FREE of any refuse and debris. Inspect seal for possible
excessive wear or damage and replace if necessary.
Report any excessive wear or damage to your supervisor.
DANGER
Stand clear when tailgate is in motion and during
unloading cycle. Do not stand under or cross under raised
tailgate. Doing so may result in injury or death.
Lower the Tailgate
1. DEPRESS and HOLD the T/G RAISE button to
RAISE the tailgate sufficiently to rotate the props out
of the prop pockets.
2. STORE the tailgate props.
3. DEPRESS and HOLD the T/G LOWER button to fully
LOWER the tailgate, then RELEASE the switch.
The BODY TAILGATE warning notification light will go
OFF and the alarm will stop when body is FULLY down
and the tailgate is completely closed.
Lock the Tailgate
DEPRESS and HOLD the T/G LOCK button until the
tailgate if fully locked.
80
To Next Page
Loading...