Issued June 2020
Operation
Copyright 2020, Heil Environmental
Printed in U.S.A.
59
Inspect body mounting brackets for cracked weld, missing bolts or nuts or movement
Inspect decals on body prop for damage and readability
Inspect level of hydraulic oil if tank is mounted on streetside. It must be full. Add recommended oil as necessary
If equipped, the hopper cover is DOWN
Battery disconnect switch is turned to OFF then:
Check wiring and battery cables from the battery box to the engine starter for wear and other damage.
IMMEDIATELY REPLACE WORN OR DAMAGED WIRING
Check wiring and cables for loose connections. IMMEDIATELY TIGHTEN LOOSE CONNECTIONS
OPERATION OF UNIT - Skip this section if the unit will not be operated today
Close the air tank drain valve
Turn battery disconnect to ON
Make sure the starter interlock operates – make sure unit will not start in gear
Start the engine. Indicator lights and gauges show normal operation of engine
Make sure the parking brake does not allow the vehicle to move forward or reverse at idle
Make sure the throttle advance (if equipped) operates only in neutral
Make sure all cab, body and tailgate lights operate
Make sure the backup alarm and light operate
Make sure all people not necessary and any hazards are clear of the area and then:
If equipped, engage the PTO
Pull the System Power knob UP – the switch’s red light is ON and the PUMP ON light is ON
To Next Page
Loading...