Instructions for use D-Vapor/D-Vapor 3000 83
Problem solving
Smell of anesthetic agent, anes-
thetic agent vapor leakage,
leakage too high during leakage
test.
Plug-in adapter not fitted flush. Check plug-in connector sealing
rings and sealing surfaces; al-
ternatively locking lever was
twisted before connection.
D-Vapor only
Leakage at connector, e.g., va-
porizer connected to Titus,
which has not been converted
for D-Vapor, see page 40.
Check that the power cable is
not trapped between the vapor-
izer and the anesthesia worksta-
tion.
Have the Titus main device con-
verted by specialized service
personnel.
Seal on filling system defective. Disconnect the vaporizer from
the mains power supply. Repair
by specialized service person-
nel.
Anesthetic agent bottle with-
drawn too quickly from the filling
opening after the filling proce-
dure.
Before removing the anesthetic
agent bottle from the filling
opening, wait until the anesthet-
ic agent has drained into the
tank. See "Ending the filling pro-
cedure" on page 45.
Filling level cannot be read in
sight glass
Vaporizer completely empty. Refill the vaporizer.
Vaporizer overfilled. Drain the vaporizer to the maxi-
mum marking. Check the con-
centration!
Sight glass display faulty. Repair by specialized service
personnel.
Anesthetic agent in sight glass
is discolored.
Vaporizer filled with incorrect
agent.
Check and drain vaporizer,
see page 69.
Repair by specialized service
personnel.
Anesthetic agent discolored yel-
low due to interaction with the
bottle.
Flush the tank with fresh desflu-
rane in portions. If necessary,
have the tank repaired by spe-
cialized service personnel.
Air in the tank. Air in tank after long period of
storage or during initial start-up.
Concentration temporarily devi-
ates downwards from the set
value.
Refill anesthetic agent.
Fault Cause Remedy
To Next Page
Loading...
