Ducati PANIGALE V4 - Front Fork Adjustment

Front fork adjustment
The front fork used on this motorcycle has rebound
(return), compression and spring preload adjustment.
Adjustment is done by external screw adjusters.
1) For rebound adjustment (1, ;
2) for compression adjustment (2, ;
3) for inner spring preload adjustment (3, Fig. 211);
Put the motorcycle on the side stand and make sure it
is stable.
Turn adjuster (1) at the top end of each fork leg with a
flat-blade screwdriver to adjust rebound.
Turn adjuster (2) at the top end of each fork leg with a
flat-blade screwdriver to adjust compression.
Turn adjusters (1) and (2) to adjust damping. The
stiffest damping setting is obtained with the adjuster
turned fully in to the "0" position. Starting from this
position, turning counter clockwise, you can count
the turns.
To change preload of the spring inside each fork leg,
turn the hex. adjuster(3, Fig. 211) with a hexagon
wrench, starting from the fully open (clockwise)
position.
STANDARD settings are as follows:
1 2
Fig. 210
3
Fig. 211
255