Light control
Low / High beam
At Key-On, the high beam and low beam lights are
OFF: only the parking lights and the DRL light are
turned on (DRL lights are not present in China,
Canada and Japan versions).
After starting the engine the high beam is
automatically turned on if the AUTO mode is set and
the instrument panel detects poor ambient light
(NIGHT): if, on the other hand, the instrument panel
detects good light conditions (DAY), the DRL light
remains on and the low beam remains off; it is
possible to switch the DRL light to low beam (and vice
versa) with button (9).
It the low beam is activated, it is possible to switch on
the high beam by pressing button (3), positions (A)
and (B). If engine is not started upon key-on, it is
anyway possible to switch high/low beams on by
pushing button (3) position (C) on LH switch.
If within 60 seconds from the "manual" switching on
of the low / high beam the engine is not started, the
lights are disabled again (off).
Light switching-off during vehicle starting
To preserve the motorcycle battery, if when starting
the engine the high/low beams or the DRL lights are
ON, the headlight is automatically switched off and
then on again when the engine is started.
Fig. 174
218
To Next Page
Loading...
