Ducati PANIGALE V4 - Trip Time (TRIP 1 TIME)

Trip time (TRIP 1 TIME)
To select this function in the Function Menu, scroll the
functions available using buttons (1) and (2) to display
“TRIP 1 TIME”.
The instrument panel calculates and shows trip time.
Value is displayed as hhh:mm followed by “TRIP 1
TIME” indication.
The calculation considers the time since Trip meter 1
(TRIP 1), Average Fuel Consumption (CONS. AVG 1)
and Average speed (SPEED AVG 1) were last reset.
The active time counting phase occurs when the
engine is running, even when the vehicle is stopped.
The time count is automatically stopped when the
vehicle is not moving and the engine is off and
restarts when the counting active phase starts again.
When the reading exceeds 511:00 (511 hours and 00
minutes), the meter is reset and automatically starts
counting from 0 again.
If button (4) is pressed when trip time is displayed, the
instrument panel will activate the warning "TRIP 1
TIME RESET ?" in place of the time. When this
warning is active, Function Menu scrolling is not
possible.
If you press button (1) or (2), the instrument panel will
display TRIP 1 TIME again, without resetting the
value.
While if you press button (4), value for TRIP 1 TIME
will be reset and the instrument panel will display
TRIP 1 TIME at “0:00”.
When TRIP 1 TIME is reset, the Trip meter 1 (TRIP 1),
Average speed (SPEED AVG 1) and Average Fuel
Consumption (CONS. AVG 1) data are also reset.
CONS. AVG 1 counter is automatically reset also in
the following cases:
T AIR
°C
22
TRIP 1 TIME
3:22
km/h
SPEED AVG.
130
1
42
Fig. 33
94