Ducati PANIGALE V4 - Instrument Panel (Dashboard); Instrument Panel

Instrument panel (Dashboard)
Instrument panel
1) DISPLAY
2) NEUTRAL LIGHT N (GREEN)
Comes on when in neutral position.
3) GENERIC ERROR WARNING LIGHT (AMBER
YELLOW)
It turns on when there are any "vehicle" errors, i.e.
active errors triggered by any control unit other than
the engine control unit.
4) HIGH BEAM LIGHT
(BLUE)
It turns on to indicate that the high beam lights are on
and when the flasher is activated.
5) FUEL WARNING LIGHT
(AMBER YELLOW)
Comes on when fuel is low and there are about 4.5
litres (1.19 gallons) of fuel left in the tank.
6) TURN INDICATOR LIGHTS
(GREEN)
Illuminates and flashes when the turn indicator is in
operation.
7) ENGINE OIL PRESSURE LIGHT (RED)
Comes on when engine oil pressure is too low. It
must turn on at "KEY-ON", but must turn OFF a few
seconds after the engine has started. It may shortly
come on when the engine is hot, however, it should
go out as the engine revs up.
Important
If the ENGINE OIL light stays ON, stop the
engine or it may suffer severe damage.
8) DAVC LIGHT (AMBER YELLOW)
This light indicates DTC/DWC/DSC system enabling/
disabling status.
- Light off: DTC/DWC/DSC enabled and
functioning;
- Light ON flashing: DTC/DWC/DSC enabled, but
with degraded performance;
- Light steady ON: DTC/DWC/DSC disabled and/or
not functioning due to a fault in the control unit.
9) ENGINE DIAGNOSIS - MIL LIGHT
(AMBER
YELLOW)
It turns on in the case of "engine" errors that in some
cases will lock the engine.
22