EasyManua.ls Logo

Ducati PANIGALE V4 - Page 67

Ducati PANIGALE V4
331 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Tips on how to select the sensitivity level
Warning
Excellent operation of the DWC system, for all
available levels, is ensured only with the OE final drive
ratio and with OE tyres and/or with the ones
recommended by Ducati. In particular, OE tyres for
this motorcycle are Pirelli Diablo Supercorsa SP in the
following sizes: 120/70ZR17 at the front, 200/60ZR17
at the rear. The use of tyres of different size and
characteristics to the original tyres may alter the
operating characteristics of the system thus making it
unsafe. It is recommended not to install tyres of
different size than the ones approved for your vehicle.
As far as the final ratio is concerned, when using a
different ratio (which only possible for tracing use)
than the original equipment one, it is recommended
to use the relevant automatic calibration function in
order to restore optimal system operation.
At level 8 the DWC system reduces the motorcycle's
proneness to do wheelies to a minimum level and
sensitively intervenes in case of wheelie. Between
level 8 and level 1 there are further intermediate levels
of intervention for the DWC. Levels 1, 2 and 3 allow
easier wheelies, but reduce their speed: these levels
are recommended only for track use and for expert
riders who can control wheelies on their own and
exploit the system feature that reduces the speed at
which the front wheel tends to lift.
The choice of the correct level mainly depends on the
following parameters:
- The rider's experience;
- The characteristics of the path/circuit (bend exit
with low or high gear engaged).
The rider's experience
The choice of level setting depends greatly on the
riders' experience and ability to control wheelies on
their own. Levels 1, 2 and 3 require a great experience
to ensure proper control.
Level depends on type of track/path
If the track/path features bends where out speed and
gear are low, a lower level will be necessary; while a
track/path with faster bends will allow the use of a
higher level setting.
Tips for use on the track
66

Table of Contents

Related product manuals