Operation
Operating Instructions 878-M PREMIUM - 02.0 - 02/2018 23
Changing the needle
Fig. 3: Inserting and replacing the needle - 1-needle machine
1. Turn the handwheel until the needle bar (1) reaches the upper
end position.
2. Draw the lever (2) in your direction to loosen the screw fixing
the needle.
3. Pull the needle out towards the bottom.
4. Insert the new needle.
5. Important: Align the needle so that the groove (3)
is facing the hook according to section (4) or (5). The needle
may not be oriented as shown at section (6).
6. Turn the lever (2) back to tighten the screw.
(1) - Needle bar
(2) - Lever
(3) - Groove
(4), (5), (6) - Orientation of needle
②
①
③
④
⑤
⑥
m
a
x
.
3
°
To Next Page
Loading...
Need help?
General
